The TK3-2 Calibration Instrument simulates shaft vibration and position for calibrating Bently Nevada monitors. It verifies the operating condition of the monitor readouts as well as the condition of the proximity transducer system. A properly calibrated system means that the monitor readings and transducer inputs are accurate.
A spindle micrometer is used to check the transducer system and position monitor calibration. A probe mounting adapter provided with the TK3-2 holds the probe while the target is moved toward or away from the probe tip in calibrated increments.
Vibration monitors are calibrated using the motor-driven wobble plate. A swing-arm holder is located over the wobble plate to hold the proximity probe in place. The holder and probe are adjusted to a position where the desired amount of mechanical vibration is found. The vibration is then measured using a dial micrometer which is supplied with the unit (no oscilloscope is needed).
A vibration monitor's reading can then be compared to the known mechanical vibration signal input. The mechanical vibration signal from the TK3-2 can range from 50 to 254 µm (2 to 10 mils) peak-to-peak.
You are guaranteed to receive next day UK delivery to your door when ordering from Inlec. All confirmed weekday orders placed before 3:00 pm will be delivered to you the next day before 12 noon, guaranteed. If you do not receive delivery by the requested delivery time we will refund your delivery charge in full.
Deliveries are made through our own delivery vehicles and by National Couriers.
Next day delivery is our standard service however, please enquire for any of the following which we will endeavour to provide at extra cost:
·pre 9am or pre 10:30 delivery
·Saturday or Sunday delivery
·Same day delivery
In addition to nationwide delivery we also ship to EU and worldwide, please call our Customer Services team on our freefone number above for prices.
To see our delivery performance click here!